Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Adjust the minutes by turning the crown and confirm by pressing P2; on the
upper screen, the seven days of the week flash one after the other from the left,
in other words, from Monday to Sunday (
every day and the seven letters are therefore lit up.
• Should one wish to delete one or more days, they must be "deleted" one by one
by turning the crown, each time confirming with a press on P2 which results in
the setting moving to the following day (example of the display on the upper
screen of an alarm set on all five working week days:
N.B.: Pressing P1 reactivates the seven days of the current alarm (
• Adjust by turning the crown, the type of alarm signal desired (display
):
(sound alarm),
SIGNAL
BUZZER
together) or
(vibrating alarm alone followed by vibrating and sound
VIB/BUZ
alarm for the reminder) and confirm by pressing P2.
• Press the crown back to neutral position 1. Upon exiting setting, the alarm set is
automatically activated, and is thus in
display was selected,
x
, or respectively
AL
AM
N.B.: If all the days of the week are deactivated, the alarm is automatically deactivated.
On the contrary, when an alarm with no active day is turned to
week are activated.
); by default, the alarm sounds
MTWTFSS
).
MTWTF__
ALLDAyS
(vibrating, silent alarm),
VIBRATE
BOTH
mode (
x
or, if the 12 hour (AM/PM)
ON
AL
ON
x
).
AL
PM
, all the days of the
ON
118
If the alarm is not configured to sound every day, when it is activated, the upper
screen alternates
no additional indication is given.
b) Use
• A press on P2 will result in displaying the first (
alarms up to the seventh alarm (
• Pressing P1 activates (
the alarm displayed.
).
• A long press on P2 starts a test of the active alarm with
ALARM
upper screen; a second press on P2 will stop the test.
(both
The alarm sounds for 20 seconds, with a 10-second reminder after 2 minutes. The
upper screen displays the name of the active alarm by flashing:
be deactivated by pressing one of the two pushpieces or on the crown.
10. CHRONOGRAPH WITH INTERMEDIATE/SPLIT TIMES AND TACHYMETER (
The
CHR ADD
given recording.
When the
CHR ADD
tically on 0 and becomes the chronograph hand. With each new recording, the
hand goes back to zero and positions itself directly above the second in progress. It
returns to its usual function when the chronograph function is exited.
x
with the days activated (ex:
AL
ON
).
AL7
x
or
x
, respectively
AL
ON
AL
AM
function allows up to 50 intermediate times to be measured in any
function is selected, the seconds hand positions itself automa-
119
); in the opposite case,
M____SS
), followed by the successive
AL1
x
) or deactivates (
x
)
AL
PM
AL
OFF
x
displayed on the
AL
TEST
to
. This can
AL1
AL7
)
CHR ADD
Publicité
Chapitres
Table des Matières
