Breitling BENTLEY SUPERSPORTS B55 Mode D'emploi page 57

• Press the crown into neutral position 1.
The watch has a perpetual calendar until 2099.
6. SETTING THE MAIN ZONE ( )
TIME
a) Setting ( )
SETTIME
• Select the or function.
TIME DATE
• Pull the crown into position 2: if the hour was displayed,
the upper screen and the setting process (in a loop) starts by the time setting.
If the date was displayed,
SETDATE
process will start with adjusting the date. In the second case, press on P2 until
the hours begin to flash (
UTC +/-
• By turning the crown, adjust the time in relation to the difference with UTC,
from to .
UTC-12 UTC+14
• Confirm by pressing P2; the minutes flash (display
• If necessary, adjust the minutes in 15-minute increments and confirm by pressing
P2; the seconds flash ( appears on the upper screen).
SECOND
• Adjust the seconds (which will automatically be adjusted in the
and confirm by pressing P2.
• Press the crown back to neutral position 1.
appears on
SETTIME
appears on the upper screen and the setting
xx).
) on the upper screen.
MIN +00
TIME 2
108
N.B.: When in setting mode (
from 0. The seconds counter only stops when the seconds are manually modified.
In this case, it restarts when exiting setting (putting the crown back to neutral
position 1). The seconds are automatically synchronized on the
timezones.
In mode, pressing P1 makes it possible to go into
TIME
date according to different formats (see chapter 8). A long press on P1 puts the
display directly back to
In mode, a long press on P2 allows to choose between either the 12-hour (
TIME
or indicator) or the 24-hour display. The change also happens automatically for
PM
the
TIME 2
7. CONFIGURING THE WATCH (
In the
SETTING
memorized by the watch and therefore available even in the event of the battery
being completely flat):
1.
SyNCHRO
2. : lighting goes on automatically (and possibly the LCD) depending on the
TILT
and )
UTC
position of the wrist (positioned around 30° to horizontal), but for a maximum
of 30 seconds, unless in the setting mode (
), pressing P1 will restart the seconds counter
SETTIME
.
TIME
zone and the seven alarms.
)
SETTING
mode, the following adjustments can be made (all these settings are
: synchronization of the analog display with the digital display.
SETTING
109
and
UTC TIME 2
mode and display the
DATE
AM
).