Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9 - "MASTER" FUNCTION
INSTRUCTIONS FOR THE INSTALLER
9.3.1) ASSIGNMENT OF ZONES TO THE "MASTERS"
(to be performed after matching transmitters, see for example paragraph 4.8).
This function can be protected by a password (see chapter ).
To assign "Master" chronothermostats to zones (channels), carefully follow instructions
found in the chapter "Preparing the receiver for operation with Master" in the receiver
instruction manual.
Activate the "Master Test" status ON THE "MASTER" CHRONOTHERMOSTAT:
•
press the
Master key for 4 seconds: MASt
ON THE RECEIVER:
•
verify zone status and perform assigning operations indicated in the receiver instruction manual.
After operations have been completed:
Deactivate the "Master - Test" status
disappears and the program previously in progress will appear on the display.
9.3.2) DELETING ASSIGNMENT OF A ZONE TO A "MASTER"
Also with deleting operations, carefully follow instructions found in the receiver instructions manual.
.
Activate the "Master Test" status ON THE "MASTER" CHRONOTHERMOSTAT:
•
press the
Master key for 4 seconds: MASt
.
ON THE RECEIVER:
•
verify zone status and perform cancelling operations indicated in the receiver instruction manual.
Deactivate the "Master - Test" status ON THE "MASTER" CHRONOTHERMOSTAT:
•
press the
Master key for one second: MASt
"Master - Test" status remains active for maximum 3 minutes, after which the chronothermostat will return to its normal operation.
96
8
"
"
will be displayed
(example in fig. 82).
ON THE "MASTER" CHRONOTHERMOSTAT,
"
"
will be disp yed
la
(example in fig. 82).
"
" disappears and the program previously in progress will appear on the display.
0
2
4
6
8
10 12 14 16 18
fig. 82
press for 4 seconds
pressing the
Master key for one second:
t1
t2
t3
20 22
"
MASt
"
Publicité
Chapitres
Table des Matières
