Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4 - INSTALLATION
4.9) RADIO SIGNAL INTENSITY VERIFICATION TEST
For this operation, carefully consult the receiver instructions
This function can be protected by a password (see chapter ).
ON THE CHRONOTHERMOSTAT
•
Press the
Test
key for 7 seconds; a
•
The symbol of an antenna
every 3 seconds (fig.
" "
E
).
ON THE RECEIVER
•
At every signal reception, 1, 2 or 3 brief acoustic signals will be emitted, based
on intensity (1= LOW, 2 = MEDIUM, 3 =HIGH) of the received signal.
•
The corresponding LED "
•
The
3 VMETER LEDs
(indicator of signal intensity) will light up briefly at each
signal reception, depending on the intensity of the received signal.
Test signal transmission will remain active for 3 minutes maximum.
Deactivating the "radio signal intensity verification test" operation
ON THE CHRONOTHERMOSTAT
•
Press the
Test
key for at least 1 second, then release (e.g. fig.
•
The program previously in progress will appear on the display.
bEEP
message will appear on the display.
will appear on the display, blinking will appear
" will blink
8
" " F
).
.
.
.
0
2
4
6
8
10 12 14 16 18 20 22
press for 7 seconds
.
.
.
0
2
4
6
8
10 12 14 16 18 20 22
press for 1 second
t1
t2
t3
fig. E
t1
t2
t3
fig. F
63
Publicité
Chapitres
Table des Matières
