Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4 - INSTALLATION
4.8) COUPLING THE CHRONOTHERMOSTAT TO THE RECEIVER (self-learning)
For this operation, carefully consult the receiver instructions
PRELIMINARY OPERATIONS
•
Install and power the receiver.
•
Program the chronothermostat as indicated in chapter . 5
This function can be protected by a password (see chapter ).
ON THE CHRONOTHERMOSTAT
•
Press the
Test
key for 4 seconds; a
•
The symbol of an antenna
every 3 seconds (fig.
" "
C
).
Test signal transmission will remain active for 3 minutes maximum.
ON THE RECEIVER
•
Perform coupling instructions indicated in the receiver instructions manual.
ON THE CHRONOTHERMOSTAT (coupling operations output)
•
Press the
Test
key for at least 1 second, then release (e.g. fig.
•
The program previously in progress will appear on the display.
The chronothermostat is coupled to the receiver.
Note: in the event of chronothermostat RESET, coupling with a receiver
will not be cancelled.
62
tESt
message will appear on the display.
will appear on the display, blinking will appear
8
" "
D
).
.
.
.
0
2
4
6
8
10 12 14 16 18 20 22
press for 4 seconds
.
.
.
0
2
4
6
8
10 12 14 16 18 20 22
press for 1 second
t1
t2
t3
fig. C
t1
t2
t3
fig. D
Publicité
Chapitres
Table des Matières
