Finishing; Safety Screen & Door Removal / Installation - Continental Fireplaces CLHD45N Instructions D'installation Et D'opération

32

6.0 FINISHING

EN
THE FRONT OF THE APPLIANCE MUST BE FINISHED WITH ANY NON-COMBUSTIBLE MATERIALS
SUCH AS BRICK, MARBLE, GRANITE, ETC., PROVIDED THAT THESE MATERIALS DO NOT GO
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
FACING AND/OR FINISHING MATERIAL MUST NEVER OVERHANG INTO THE APPLIANCE OPENING.
6.1 SAFETY SCREEN & DOOR REMOVAL / INSTALLATION
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and shall be installed.
Before the glass door can be removed, the safety screen must be removed. Lift the safety screen off the 4
screws, tilt the top forward and remove from the appliance.
The glass door is secured to the top front edge of the fi rebox with two
latches. Pull the handles of the latches forward, then lift the latches out
from the door frame to release the top of the door. Next, pivot the door
forward until the top edge clears the front of the appliance. Carefully grip
the sides of the door lifting it out from the retainer along the bottom of
the door.
Reverse these steps to re-install the safety screen and door.
Ensure safety screen is installed correctly.
W415-1336 / 08.21.14
NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.
BELOW THE SPECIFIED DIMENSION AS ILLUSTRATED.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
WARNING
!
RISK OF FIRE!
WARNING
!
72.1A
75.1