Optional Blower Installation; Accessing The Blower; Burner Removal - Continental Fireplaces CLHD45N Instructions D'installation Et D'opération

36

7.0 OPTIONAL BLOWER INSTALLATION

EN
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
ENSURE THAT THE FAN'S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
HELPFUL HINT: Prior to fi nishing in the appliance, we recommend installing the blower through the
pre-fi nishing access panel.
7.1

ACCESSING THE BLOWER

BE CAREFUL NOT TO TEAR THE BURNER TRAIN GASKET. A REPLACEMENT GASKET CAN BE OR-

7.1.1 BURNER REMOVAL

Remove the door, see "DOOR REMOVAL / INSTALLATION" section.
A.
Remove the 20 screws (8 per side and each corner) that secure the media tray in place. Using the lift-
B.
ing handles lift the tray up and out.
Remove the 4 screws that secure the burner in place. Lift the burner up and out.
C.
LIFTING
HANDLES
W415-1336 / 08.21.14
RISK OF FIRE AND ELECTRICAL SHOCK.
VOID THE WARRANTY AND CERTIFICATION.
CORD BENEATH THE APPLIANCE.
CONTACT WITH MOVING OR HOT OBJECTS.
DERED FROM YOUR LOCAL AUTHORIZED DEALER / DISTRIBUTOR.
MEDIA
TRAY
WARNING
!
WARNING
!
51.5
BURNER