Program Cards - Medela Symphony Mode D'emploi

Symphony ® Controls
8
Symphony ®

Program Cards

There are two versions of the Symphony Program Card:
the Original Symphony Program Card and the Symphony
2.0 Program Card. The following information is instruc-
tions for either card.
Original Symphony Program Card
The original Symphony Program Card is programmed to
operate the 2-Phase Expression.
1 1
LCD Display.
When powered off and connected
to A/C power supply, the LCD
Display will indicate "Mains".
When batteries are used to power
the Symphony, the LCD Display will
remain blank until powered on.
The vacuum setting is indicated on the LCD Display
with Drops (Stimulation) and Bars (Expression).
2 2
Begin in Stimulation Phase.
Start the pump by pressing the
on/off button. The pump will
immediately begin pumping in
the Stimulation Phase. The initial
vacuum level will be indicated by
1 drop on the LCD Display.
Stimulation Phase is always limited to two minutes.
3 3
Switch to Expression Phase.
The pump will switch to Expression
Phase by one of two ways:
1) automatically, after two minute
Stimulation Phase is complete, or
2) by pressing the let-down button.
You should press the let-down
button immediately after milk ejection and continue
pumping in the Expression Phase.
9