Operation; Battery Fitting And Replacement; Initial Power Up - Megger TDR2000/2 Guide De L'utilisateur

OPERATION

Battery Fitting and Replacement

For TDR2000/2
When the battery low symbol
the cells are nearly exhausted and should be replaced as soon as possible.
Use alkaline cells IEC LR6 (AA) 1.5 V or 1.2 V rechargeable cells only.
To install or replace the cells, switch the instrument off. Disconnect the
test leads, loosen the battery cover retaining screws and remove the cover.
Lift out and disconnect the battery holder. Replace the cells, ensuring that
correct polarity is observed (shown on the battery holder).
Incorrect battery cell polarity can cause electrolyte leakage resulting in
damage to the instrument
Refitting the battery holder is the reverse of removing it.
For TDR2000/2R, TDR2000/2RM and TDR2000/2P
When the battery low symbol
Connect the Battery charger to the TDR charger socket. Switch on the
Charger. Allow 14 hours to fully charge the TDR2000/2R.
appears in the display window
appears, switch off the unit.
Initial Power Up and Configuration
The first time the TDR2000/2 is switched on the operator will be asked to
choose a language. There are five languages (English, French, German,
Spanish and Italian) stored in the instrument. The selected language will
become the default language for the instrument.
A sixth language is 'user definable' and can be uploaded from the
Tracemaster CD.
Uploading languages
In Tracemaster:
I
Select UPLOAD LANGUAGE FILE from the OPTIONS menu
I
Select a language and press OPEN.
On the instrument:
I
Connect the communication lead from the serial connector of
the TDR/CFL to the serial port of the PC.
I
Switch on the TDR2000/2
I
Press UPLOAD/DOWNLOAD key
The selected language should now transfer to the TDR2000/2.
9