Safety Warnings - Megger TDR1000/2 Guide De L'utilisateur

Although this tester does not generate any hazardous voltages, circuits to which it can be connected could be dangerous
due to electric shock hazard or due to arcing (initiated by short circuit). While every effort has been made by the
manufacturer to reduce the hazard, the user must assume responsibility for ensuring his, or her own safety.
For use on energised systems rated up to 300V Installation Category III* the fused clip set Megger Part
Number 2000-151, must be used.
* Relates to the transient over voltages likely to be met in fixed wiring installations.
4mm plug to BNC Adaptor:
This 4mm plug to BNC adapter is intended for use with telecomm network cables only, it is not designed or intended for
direct connection to an energised mains supply. However, in normal use it may be subject to telecom network voltages
(TNV) as defined by IEC 60950 3rd edition (1999-04).
The BNC plug and socket are, by necessity, accessible. The outer sheath for this connector is normally at SELV levels,
however under single fault conditions it may carry hazardous voltages. The operator must therefore verify that the
accessible plug or socket is at SELV levels prior to touching, or alternatively wear appropriate insulated gloves.
•
The instrument should not be used if any part of it is damaged.
•
Test leads, probes and crocodile clips must be in good order, clean and with no
•
Check that all lead connections are correct before making a test.
•
A Fused Lead Set must be used to connect to energised live systems. Refer to the accessories section for options.
•
Disconnect the test leads before accessing the battery compartment.
•
Refer to operating instructions for further explanation and precautions.
•
Safety Warnings and Precautions must be read and understood before the instrument is used.
They must be observed during use.
the instruments must only be used by suitably trained and competent persons

SAFETY WARNINGS

note
broken or cracked insulation.
.
3