Safety Information - Megger DCM1500 Manuel De L'utilisateur

G

Safety Information

To ensure safe operation and service of the meter,
follow these instructions. Failure to observe warnings can
result in severe injury or death.
Avoid working alone so assistance can be rendered.
To enhance safety, test leads should be disconnected from
instrument when not in use
Do not use test leads or the clamp meter if they
look damaged
Do not use the clamp meter if the tester is not operating
properly or if it is wet.
Use the clamp meter only as specified in the instruction
card or the protection provided by the clamp meter may be
impaired.
Special precautions are necessary when operating in
situations where exposed live parts at dangerous voltages may
be encountered. Personal protective equipment (not supplied
with the instrument) should be used.
The test leads should be disconnected from the instrument
when making a current measurement.
Use caution with voltages above 30 V AC RMS, or 60 V DC.
These voltages pose a shock hazard.
Symbols as marked on the meter and
instruction card
F
Risk of electric shock
G
See instruction card
d
DC measurement
t
Equipment protected by double or reinforced insulation
Battery
g
Earth
a
AC measurement
c
Conforms to EU directives
G
Caution: If the meter is used in the vicinity of equipment which
generates electromagnetic interference, the display may become unstable
or the measurements may be subject to large errors.
3