Safety Warnings - Megger WM6 Guide De L'utilisateur

The circuit must be de-energized and isolated BEFORE connections are
made for any test.
Do not touch the circuit during an insulation test.
After insulation tests, capacitive circuits MUST be allowed to discharge
BEFORE disconnecting the test leads.
Test leads, including prods and crocodile clips, must be in good order;
clean and having no broken or cracked insulation.
Replacement fuses must be of the correct type and rating.
Refer also to page 8 for further explanations and other precautions.
The warnings and precautions must be read and understood before the
instrument is used. They must be observed during use.
This instrument must only be used by suitably trained and competent persons.
2

SAFETY WARNINGS

NOTE