FAR KM2727 Manuel D'utilisation page 42

ENGLISH
7. Place the grinder housing that was assembled
complete with the filler neck upwards into
the spiral drive, then release the lever until it
fixed.
8. Place the food tray on the filler neck of the
grinder housing.
9. Place a container under the exit.
10. Put the meat on the food tray and into the
filler neck.
11. Connect the device to a 220-240 V, 50 Hz safety
contact power socket.
12. Adjusting the levels at 5-6 by the speed knob.
13. If necessary push the meat with the food
pusher. Please do not follow this up with
your fingers
GB-28
Operation with Kubble Attachment
(illustration B)
illustration B
Note: The Kubble mixture is prepared by
mincing meat and then passing the mincing
meat with the ingredients, wheat and onions.
Repeat this till you reach the desired consistency.
1. Please ensure that the speed knob is turned
to "0".
2. Place the feed screw into the grinder
housing.
3. Place the Kubble attachment A and B on the
end of feed screw.
4. Screw the locking nut on until it is "hand
tight".
5. Take out the release lever and remove the
front cover from the top housing.
ENGLISH
GB-29