FAR KM2727 Manuel D'utilisation page 37

ENGLISH
e.g. batter for (pan) cakes.
6. Fit the attachment into the drive shaft of
the top housing from below. When doing
so, make sure that the little lugs on the shaft
are inserted into the crosswise slot of the
attachment.
7. Press the attachment lightly in and turn
counterclockwise until it engages.
8. Press the tilt knob and swing the top housing
down into the working position.
Note: Press the tilt knob round fully and hold
until the top housing is right down. Then swing
the tilt knob back again.
The appliance is now ready to use.
GB-18
Fitting the blender jug:
Caution!
• Do not use the blender jug and the mixing
bowl at the same time. This might overload
the appliance.
1. Slide the rear cover backward.
2. Take the rear cover off.
3. Position the blender jug so that the triangle
symbol aligns the triangle symbol.
4. Turn the blender jug clockwise until it
engages.
Dismantle appliance
1. Press the tilt knob and swing up the top
housing.
Note: Press the tilt knob round fully and hold
until the top housing is right down. Then swing
the tilt knob back again.
ENGLISH
GB-19