Publicité
Les langues disponibles
Les langues disponibles
Assembly of the standard
• Place the lower part of the stand (with the mounting plate) on the base. Turn the
foot over and screw the lower part of the stand from the bottom of the foot with
the plate and the locknut. Put the foot upright again. Place the protective cap
over the connection.
• Insert the middle part of the stand into the lower part, screw holes on screw
holes. Fix it in place with four fixation screws. In the same way you attach the
upper part of the stand (with the adjustable part in it) over the middle part.
• Slide the slide-out section up and see it with the supplied black self-tap.
• Place the socket with the extension cord on the lower part of the stand with the
socket facing up. Fasten it securely with the supplied brackets and screws
• Attach the Eurom Golden or Q-Time patio heater to the stand with the supplied
locknut.
• Check that all connections are firm and that the device is securely in place
before you use it. The device must be firm and stable on a flat, completely
horizontal surface.
Fall protection
The extra socket is equipped with a fall protection. So if it should fall over despite
your precautions, it will automatically switch off. In this case, immediately remove
the plug from the socket.
Carefully check the device attached to the stand for damage and put it back up. Never
operate a damaged device, but present it to your dealer or an authorized service
point for inspection and / or repair! If no damage is found, switch off the device, plug
in the power cord and restart the device. Keep a close eye on the device for the first
15 minutes; if malfunctions still occur, switch it off immediately and offer it to your
dealer / service point for repair.
Removal
In the EU this symbol indicates that this product may not be
disposed of as ordinary household waste. Old equipment
contains valuable materials, suitable for recycling. These
materials should be made suitable for reuse in order to prevent
any adverse effects to health and the environment caused by
unregulated waste collection. Therefore, please make sure that
you bring old equipment to a designated collection point.
Alternatively, contact the original supplier, who can make sure
that as many of the components as possible can be recycled.
8
Publicité
