GYS PULSFEED 4L Mode D'emploi page 32

PULSFEED 4L EN
MACHINE CONTROL AND MAINTENANCE DETAILS
Machine maintenance or alteration should only be carried out by a qualified person. Failure to comply may void the warranty. Any maintenance or
action performed on the machine should be done with power supply off (machine disconnected from the power supply network), wait at least 5
minutes before any operation, block access to the installation if necessary.
Daily :
- Check the torch, the rollers and the tightening, the connections.
Twice a year :
- Clean the inside of the machine with a compressed air cleaner.
- Make sure not to put any conductor inside the machine, such as the torch.
- Check the wear and coupling of the connections, retighten if necessary.
- Check the following parts: electrical, gas, wire reel support, wire-feeding motor and bottle support.
32