GYS PULSFEED 4L Mode D'emploi page 27

Cables calibration :
Cable calibration aims to compensate cables' lentgh by adapting the arc length settings. This is done by creating a short-circuit between the torch and
the earth clamp by following the procedure on screen.
Wire feeding motor calibration:
The calibration aims to have a highly precise wire feeding speed as soon as the trigger is pulled, this must be performed every time the wire feeder
is changed or when a full update is performed.
PULSFEED 4L
Time and date settings :
This section is used to set the date and time on the machine (useful when saving parameters).
Job mode :
: Replace the current program.
: Create a new save.
: Load a saved slot.
: Delete the current program.
: Can transfer programs from the machine to the SD card.
: Can transfer programs from the SD card to to the machine.
Saved slot visual example.
EN
27