Setting The Security Alert [Security Alert]; Device Control - Panasonic WX-CC411 Mode D'emploi

Setting the security alert [Security Alert]

This function is used to set the operations to be performed
when a security alert notice is received from button F of an
All-In-One Headset or Belt Pack or from alert inputs 1 to 4.
You can select the operations to be performed when a
security alert occurs from the following.
Message
The alert message is played back repeatedly at
intervals of 5 seconds while the security alert is
occurring.
Camera Monitoring
The NW camera image is output to the LCD display
while the security alert is occurring. You are required to
set the NW camera from the browser in advance.
For details, refer to Operating Instructions <Browser
Guide>.
Note
w p When the image of the Network Camera is displayed
on the LCD display interlocked with the security alert,
it is framed in red.

Device Control

The device control terminal is controlled while the
security alert is occurring. This is used to control the
external devices.
TALK & PAGE Recording
Communications ([TALK] and [PAGE]) in the lane to
which the All-In-One Headset or Belt Pack are set
are recorded on the SD card while a security alert is
occurring. You can record communications for up to 5
minutes. You can only select the security alert caused
by pressing button F of an All-In-One Headset or Belt
Pack.
Send E-mail
Emails are sent when an alert occurs and stops. To
send emails when a security alert occurs, set your
browser.
For details, refer to Operating Instructions <Browser
Guide>.
1
On the Settings screen, touch the [Security
Alert] button.
w p The following types of security alerts are displayed.
[F Button]
Set the operations to be performed when a security
alert occurs by pressing button F on an All-In-One
Headset or Belt Pack.
Note
w p A security alert caused by pressing button F ends
automatically 2 minutes after it occurs. If another
security alert caused by pressing button F is received
while the first security alert is still sounding, the time
until the alert ends is increased by 2 minutes.
[Alert 1 to 4]
Set the operations to be performed when a security
alert is output from alert input terminals 1 to 4.
2
Set the operations to be performed when a
security alert occurs.
When the [F Button] is selected
[Message]
Touch the [Select] button to select the alert message to
be played back when a security alert occurs.
OFF:
Message number: Alert message is played back.
Default setting: OFF
[Camera Monitoring]
Touch the [Select] button to select a Network Camera to
be displayed on the LCD display when a security alert
occurs.
OFF:
The image of the Network Camera is not
displayed on the LCD display.
Camera No.: The image of the selected Network
Camera is displayed on the LCD display.
Default setting: OFF
36
Alert message is not played back.