Setting The All-In-One Headset Or Belt Pack [Headset] - Panasonic WX-CC411 Mode D'emploi

Setting the Center Module
w Setting the All-In-One Headset
w
or Belt Pack [Headset]
The Headset is a general term for All-In-One Headset or
Belt Pack. The following are the procedures for performing
related settings.
How to register an ID
w p To talk or page using an All-In-One Headset or Belt Pack,
its ID must be registered.
w p For ID registration, set the Center Module to ID
registration mode, and proceed with the registration by
operating the All-In-One Headset or Belt Pack concerned.
The ID registration procedure is described below, based on
an example involving the operation of an All-In-One Headset
or Belt Pack.
1
On the Settings screen, touch the [Headsets]
button, and then the [ID Registration] button.
w p The ID registration screen appears.
Note
w p The registered All-In-One Headset or Belt Pack numbers
are displayed in the [Registered Headsets] area. When ID
registration is completed successfully, the ID of the newly
registered All-In-One Headset or Belt Pack is added.
2
Touch the [Start] button.
w p The following confirmation pop-up screen is
displayed. You cannot perform other operations
during ID registration. To continue ID registration,
touch the [YES] button. To stop ID registration, touch
the [NO] button.
w p Touch the [YES] button to start ID registration mode.
The number of the All-In-One Headset or Belt Pack that has
been registered is displayed.
3
Press the [POWER] button while holding down
the [T1] button and [T2] button of the All-In-
One Headset or Belt Pack.
w p The All-In-One Headset or Belt Pack starts up in ID
registration mode. The "Registration Mode" voice
prompt will be heard from the earphone, and the
power indicator will blink orange.
In ID registration mode, the buttons and indicators
have different functions from those at normal startup.
14