Setting The Messages [Message]; Recording Messages - Panasonic WX-CC411 Mode D'emploi

Setting the messages [Message]

This function is used to set the greeter message, reminder
message, and alert message.
Greeter message
This message is played back automatically from the
order post speaker when the vehicle detector detects a
vehicle at the order post.
Reminder message
This message is played back at fixed times to urge the
store personnel to work.
Alert message
This message is played back to notify store personnel
that a security alert has occurred.
When using the greeter message, reminder message, and
alert message, they must be recorded in advance.
Note
w p The messages are recorded on an SD card. When
using the messages, always insert the SD card.
Message number
Messages are controlled by message number. One of the
following letters is attached to the front of each message
number to indicate the type of message.
G: Greeter message
R: Reminder message
A: Alert message
Example) G03: Indicates the third Greeter Message.
w Recording messages
w
As an example, the procedure for recording a greeter
message is explained below. You can also record the
reminder message and alert message using this procedure.
1
On the Settings screen, touch the [Message]
button, [Greeter Message] button, and then the
[Message] button.
2
Touch the button of the message number that
you will record from the message list.
3
Touch the [REC] button.
w p The following confirmation pop-up screen is
displayed. You cannot perform another operation
while a message is being recorded. To continue
recording, touch the [YES] button. To stop recording,
touch the [NO] button.
w p When you touch the [YES] button, the following
screen is displayed.
27