Setting The Help Contact - Panasonic WX-CC411 Mode D'emploi

Setting the Center Module
[IP Address]
Set the IP address.
Touch the [Edit] button, and then input the IP address.
Default setting: 192.168.0.50
[Subnet Mask]
Set the subnet mask address.
Touch the [Edit] button, and then input the address.
Default setting: 255.255.255.0
[Default Gateway]
Set the default gateway address.
Touch the [Edit] button, and then input the address.
Default setting: 192.168.0.1
[Line Speed]
Specify the baud rate of the network.
Touch the [Select] button, and then select a baud rate.
Select a baud rate from the following.
Auto: The baud rate is set automatically.
100M-Full: 100Mbps Full duplex
100M-Half:
100Mbps Half duplex
10M-Full: 10Mbps Full duplex
10M-Half: 10Mbps Half duplex
Default setting: Auto
2
Touch the [Set] button.
w p The following confirmation pop-up screen is
displayed. To enter the change made to the network
settings, touch the [YES] button.
Note
w p When the network setting is changed, the system
restarts automatically.
w p Touch the (Setting Information button) on the
touch panel, and then touch the [System Info] button
to check the network status.
w Setting the help contact
w
"Help Contact" is a function that allows you to check the
emergency contact number on the Help Contact screen.
Input the phone number to be displayed on the Help Contact
screen.
1
On the Settings screen, touch the [Installation
Settings] button, and then the [Help Contact]
button.
Touch the [Edit] button to input the phone
number.
2
Touch the [Set] button.
w p The Help Contact settings are entered.
Note
w p Touch
touch panel, and then touch the [Help Contact] button
to check the phone number that you input.
w p You can input up to 18 numerals and symbols ("-").
12
(Setting Information button) on the