Shipping Bracket; Bowl, Mesh And Rock Placement - Napoleon GD82NT-TE Instructions D'installation Et D'opération

34
6.3

SHIPPING BRACKET

Before installing the bowl and rocks, you must fi rst remove the shipping
EN
bracket. Lift up to remove.
6.4

BOWL, MESH AND ROCK PLACEMENT

Carefully slide the opening in the rear of the
A.
bowl over the burner making sure to line the
holes in the bottom of the bowl with the 2
locating pins on the burner bottom.
UNDERSIDE OF ROCK CLUSTER
Carefully place the rocks on the bowl by lining
C.
up the locating notches on the underside of
the rock cluster with the tabs in the rear of the
bowl.
W415-1410 / 11.20.14
SCREW W/ SPACER
TABS
Place the steel mesh inside the bowl making
B.
sure there is even space between the mesh
and edge of bowl.
TOP SIDE OF ROCK CLUSTER
After rocks have been placed on the bowl,
D.
add the remaining rock by inserting the pin
into the hole as shown.