Wiring Diagram / Electrical Information; Electrical Connection; Hard Wiring Connection; Schematic - Napoleon GD82NT-TE Instructions D'installation Et D'opération

36

7.0 WIRING DIAGRAM / ELECTRICAL INFORMATION

7.1

ELECTRICAL CONNECTION

EN
DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIED
SERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THE
RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THE
APPLIANCE WALL SWITCH. INCORRECT RIGGING WILL DAMAGE CONTROLS.
ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE
WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1
CANADIAN ELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OF IF THE GAS SUPPLY HAS RAN OUT,

7.1.1 HARD WIRING CONNECTION

It is necessary to hard wire this appliance.
Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired.
This appliance must be electrically connected and grounded in accordance with local codes. In the absence
of local codes, use the current CSA C22.1 Canadian electrical code in Canada or the ANSI/NFPA 70-1996
National electrical code in the United States.

7.1.2 SCHEMATIC

Wire
Harness
Plug
W415-1410 / 11.20.14
NFPA NO. 70 IN THE UNITED STATES.
WITH THE GLASS DOOR OPENED OR REMOVED.
ACS/IPI Switch
Fan Night Lights
120V OUT
FAN
AUX OUT
POWER
COM
Control Module
Receiver
Wire Harness
WARNING
!
ELECTRICAL CIRCUIT.
Valve
Electronic Modulation
Wire Harness Assembly
Spark Electrode
Flame
Sensor
EI
Pilot
Pilot
Ground
Wire
IPI Board