Notes On Battery Usage; Storing The Scanner - Kodak P461 Guide De L'utilisateur

N o t e s o n B a t t e r y U s a g e

We recommend using rechargeable Ni-MH type batteries for optimal number of scans. Rechargeable battery life in 600dpi
averages 100+ scans per charge. Actual battery life may vary based on usage.

We do not recommend or support alkaline batteries. For acceptable battery life, and to make sure your scanner operates
dependably, use recommended batteries.

Note that there is no battery charging function in the scanner.

Always ensure that the batteries are installed with the positive and negative terminals in the correct direction as shown in the
battery compartment.

Different types of batteries have different characteristics. Do not mix different types.

Do not mix old and new batteries. Mixing old and new batteries shorten battery life or causes chemical leaks from the old
batteries.

Chemicals which leak from batteries may cause skin irritation. If any chemical matter seeps out of the batteries, wipe it up
immediately using a dry cloth, and replace the batteries as soon as possible.

When the scanner indicates "battery low" in "ready for use" status, replace batteries before beginning a scan to avoid the
scanner from stopping during the scan.
S t o r i n g t h e S c a n n e r
If the scanner will not be used for a prolonged period of time, follow the instructions below to store the scanner for future use.
1. Disconnect the scanner from power supply.
2. Place the scanner and power adapter in a box or bag to keep them from accumulating dust.
3. Place it in a cool and dry place, inaccessible to small children.
4. To avoid warping the top housing, do not place heavy objects on top of the scanner.
5. After long-term storage, it is recommended that you clean and calibrate the scanner before use.
20 Customer Support: http://www.pandigital.net/kodaksupport
Insert the calibration card into the photo feed slot as shown.
The scanner scans the pattern on the calibration card and performs calibration to the sensor inside
automatically.
Make sure that the calibration card is inserted in the correct direction. Otherwise the calibration
won't work.