Tool Specifications; Intended Use; Machine Elements - Würth master HKS 55 Combi Notice D'utilisation

HKS 55.book Seite 14 Dienstag, 14. Oktober 2008 10:22 10

Tool Specifications

Circular Saw
Article number
Power consumption
No-load speed*
Mounting bore of the saw blade 20 mm
Saw blade dia.
Max. cutting depth at 90°
Max. cutting depth at 45°
Weight
*Energy-rich, high-frequent interferences can
cause speed fluctuations. These disappear again
as soon as the interferences have died down.

Machine Elements

1 Sawdust ejector/connection for dust extraction
2 Locking screw for bevel-angle adjustment
3 Parallel guide
4 Retracting blade guard
5 Fastening screw
6 Locking screw for parallel guide
7 Adjustment screw for glide rail (accessory)
8 Auxiliary handle
9 Clamping lever for retracting blade guard
10 Lock-off button
11 On/Off switch
12 Handle
13 Bevel-angle scale
14 Cord guide
15 Overload indicator
16 Thumbwheel for speed preselection
17 Lever for depth-of-cut adjustment
18 Allen key
19 Cutting-depth scale
20 Cutting-depth stop
21 Lever for cutting-depth stop
22 Saw blade
23 Clamping flange
24 Spindle lock button
25 Adjusting screw
26 Lock nut
Not all of the accessories illustrated or described are included
as standard delivery.
14
The machine is intended for cutting wood length-
HKS 55 Combi
ways and crossways in straight lines and at mitred
0702 157 X
angles of up to 45° on a firm surface.
1200 W
Observe the recommendations for saw blades.
2000 -
The user is responsible for damage caused by usage
-1
5200 min
other than intended for.
160 mm
Adjusting the Cutting Depth/
55 mm
40 mm
3.4 kg
Before any work on the machine itself, pull the
plug from the socket!
Adjusting the Cutting Depth
(see main figure)/figure A)
– Loosen clamping lever 17 and set the machine to
the uppermost position.
– Release lever 21. Adjust the desired cutting depth
with the stop 20 at scale 19. Tighten lever 21
again.
– Press the machine downward and tighten clamp-
ing lever 17.
Adjusting the Bevel Angle
(see main figure)
The bevel angle can be adjusted between 0° and
45°.
– Slacken the locking screw 2.
– Set the bevel angle by tilting the base plate 10.
The angle can be read on the bevel scale 13.
– Tighten the locking screw 2.

Intended Use

Bevel Angle
For optimal results, allow the saw blade to
protrude from the workpiece by about
5 – 8 mm.