Tool Specifications; Before Use; Initial Operation; Dust Protection - Würth SBS 1100-E Traduction Des Instructions De Service D'origine

SBS 1100-E.book Seite 9 Dienstag, 13. Februar 2018 8:27 08

Tool Specifications

Sabre Saw
Article number
Input power
Output power
Stroke rate at no load
Stroke
Weight
Safety class

Before use

Always use the correct supply voltage: The power
supply voltage must match the information quoted
on the tool identification plate.
Inserting the saw-blade
(see figure )
A B
Always disconnect the plug from the socket
before carrying out any work on the machine.
Turn the clamping ring 4 to loosen the saw blade
holder.
Insert the saw blade 1 to the stop into the saw
blade holder. To clamp the saw blade, turn the
clamping ring 4 in the opposite direction. Check
the tight seating of the saw blade (wear protective
gloves!).
If required, the saw blade 1 can also be mounted
turned by 180°.
Only use saw blades with adequate length. The
saw blade has to be longer than the working
piece even when working with the lowest stroke
rate (H). Saw blades can break if hit against the
working piece or the guide shoe.

Initial Operation

Switching On and Off
To start the machine, press the On /Off switch 3 and
keep it depressed.
The machine runs with variable speed between 0
and maximum, depending on the pressure applied
to the On/Off switch 3. Light pressure on the On /
Off switch 3 results in low rotational speed, thus
allowing smooth, controlled starts. Further pressure
on the switch results in an increase in speed.
To switch off the machine, release the On /Off
switch 3.
If you want to saw a cut into a panelled wall, check
SBS 1100-E
beforehand if there are any electric or other cables
5706 540 X
in the area to be sawn (eg. with metal detector).
1100 W
When sawing, only hold plastic parts of machine.
550 W
This will prevent an electric shock should you saw
–1
0 – 3000 min
through a cable.
19 mm
In order to avoid vibrations press the guide shoe flat
3.2 kg
to the working material when sawing.
/II
Sawing metal
When sawing into metal start with a low stroke rate,
then increase the stroke rate by depressing the
switch. For plunge cutting, first drill a hole which is
slightly larger than the saw blade and then start to
cut.
When sawing into metal apply coolant and lubricant
(oil, paraffin oil) along the cutting line.
Plunge cuts (see figure
Plunge cutting is only possible in soft materials.
Switch on machine and rest guide shoe on work-
piece, hold housing firmly with one hand at the top
and with your other hand push upwards on the hand
grip, slowly plungeing in the saw blade.
Dusts from materials such as lead-containing
coatings, some wood types, minerals and metal
can be harmful to one's health. Touching or
breathing-in the dusts can cause allergic reac-
tions and/or lead to respiratory infections of the
user or bystanders.
Certain dusts, such as oak or beech dust, are con-
sidered as carcinogenic, especially in connection
with wood-treatment additives (chromate, wood
preservative). Materials containing asbestos may
only be worked by specialists.
- Provide for good ventilation of the working
place.
- It is recommended to wear a P2 filter-class res-
pirator.
Observe the relevant regulations in your country
for the materials to be worked.
Operating Instructions
)
C

Dust Protection

9