Display Settings; Fixture Test - Briteq BT-W12L10 ZOOM Mode D'emploi

ENGLISH OPERATION MANUAL

Display Settings

This submenu contains all display related settings.
 Press the MENU button and select the "Display Settings" submenu.
Display Inverse
The projector can be fixed/used in upward position or hung in upside-down position. To make reading of the
display easier, you can turn it over 180°.
No: Display readable while the projector is in upward position.
Yes: Display readable while the projector is in upside-down position.
 Select "Display Inverse" and press ENTER
 Use DOWN / UP buttons to select Yes or No.
 Press the ENTER button to save.
To return without any change or go to a previous menu, press the MENU button.

Notice an alternative shortcut for this function: press the UP & DOWN buttons together.
Backlight Auto Off
No: display is always lit.
Yes: display turns dark when not used for some time.
 Select "Backlight Auto Off" and press ENTER.
 Use DOWN / UP buttons to select Yes or No.
 Press the ENTER button to save.
To return without any change or go to a previous menu, press the MENU button.
Backlight Intensity
Used to set the intensity of the display backlight.
 Select "Backlight Intensity" and press ENTER.
 Use DOWN / UP buttons to change the intensity between 1 and 10.
 Press the ENTER button to save.
To return without any change or go to a previous menu, press the MENU button.
Temperature Unit
The display can show temperature either in °C (Celcius) or °F (Fahrenheit)
°C: Temperature is shown in Celcius.
°F: Temperature is shown in Fahrenheit.
 Select "Temperature Unit" and press ENTER.
 Use DOWN / UP buttons to select °C or °F.
 Press the ENTER button to save.
To return without any change or go to a previous menu, press the MENU button.
Display Warning
You can choose if the projector warns you that an error occurred.
No: display only shows the error discretely
Yes: the display starts blinking while the error is shown on the display.
 Select "Display Warning" and press ENTER.
 Use DOWN / UP buttons to select Yes or No.
 Press the ENTER button to save.
To return without any change or go to a previous menu, press the MENU button.

Fixture Test

This submenu contains some features to quickly test the unit without the need for a controller.
 Press the MENU button and select the "Fixture Test" submenu.
Auto Test
The uit performs an automatic test where all features are shown.
 Select "Auto Test" and press ENTER.
 The projector starts the automatic test function and returns to normal operation after the test.
To return to a previous menu or stop the test, press the MENU button.
BRITEQ 6/73 BT-W12L10 ZOOM
®