Quickclean Cleaning Adapter - Storch Airless ST 550 Mode D'emploi

QuickClean cleaning adapter to efficiently clean STORCH Airless devices
ST 550 - 700 - 800
The QuickClean adapter requires a water connection, a
water hose with connection coupling (e.g. Gardena) and a
bucket to collect the dirty water.
Proceed as follows:
Original instruction
1. Ensure the Airless
gun
trigger has been locked
and the reversing tip
has been removed from
the tip holder.
2. Remove the vacu-
um hose from the
container and clean it
(including vacuum fil-
ter) on the outside with
water or a compatible
solvent. Unscrew the
vacuum filter from the
vacuum pipe and clean
the container.
3. Screw the cleaning
adapter onto the thread
of the vacuum pipe.
4. Connect the water
hose including connec-
tion coupling to the
cleaning adapter and
the water connection.
5. Turn the pressure
governor in anti-clock-
wise direction to the
lowest position, up to
the mechanical stop.
208
6. Open the pressure
relief valve and check
on the pressure gau-
ge that the system is
depressurised and the
display shows "0 bar".
Note: read Section
"Designation of compo-
nents D"
7. Place the circulati-
on hose in an empty
bucket and open the
water valve.
8. Switch on the Air-
less device at the On/
Off switch, slowly turn
the pressure regulator
to "9 o'clock positi-
on" (the motor slowly
starts) and rinse until
clear water escapes
from the circulation
hose.
9. Hold the Airless gun
into and at the inner
edge of the bucket
with the collected
waste water, unlock
the trigger lock on the
Airless gun and pull
and hold the trigger on
the gun.
10. Now close the
pressure relief valve
and water now flows
through the Airless
hose and the gun. Now
rinse until clear water
escapes. Change bet-
ween the two circuits
by opening and closing
the pressure relief val-
ve.
Note: Read in Section
"Designation of compo-
nents D+E"