Software - Migatronic SIGMA 300 Manuel D'instruction

In case of exchange of the control unit, software must
be reloaded, using an SD card.
Latest software can be downloaded under Product
software at www.migatronic.com
Save the software on an SD card containing the
folders and one or more of the files shown below.
To order SD card, use item no. 26460002.
Software reading
 Remove the left side plate on the MWF 50/55
(must be carried out by electrically skilled
person).
 Insert the SIGMA SD-card in card holder at the
PCB.
 Turn on the machine
 The display flashes shortly with six lines.
 Wait until the set current is displayed.
 Turn off the machine, remove the SD card and
mount the side plate.
 The machine is now ready for use.

SOFTWARE


All machine user settings are deleted when
the file 106454xx.bin has been inserted.
Therefore, always remove the SD-card from the
machine after the software update. Thereby,
continuous software update is avoid each time
the machine is turned on.
If the SD-card contains software for other units e.g.:
10020115.cry
10020113.cry
These units will be updated if they are connected to
the CAN network.
Please note that this update will be longer in time, so
please do not turn off the machine until the standard
control panel will be displayed at SIGMA.
21
RWF
RCI