Minimum Clearance To Combustible Enclosures - Napoleon LV38N Instructions D'installation Et D'opération

34
5.4

MINIMUM CLEARANCE TO COMBUSTIBLE ENCLOSURES

EN EN
THE FRONT OF THE APPLIANCE MUST BE FINISHED WITH ANY NON-COMBUSTIBLE MATERIALS
SUCH AS BRICK, MARBLE, GRANITE, ETC., AS LONG AS THESE MATERIALS NEVER OVERHANG
IMPORTANT: The LV38 requires a minimum inside enclosure height of 64" (162.6cm) for see-through and
55" (139.7cm) for single sided, measured from the bottom of the appliance. For temperature requirements,
this area must be left unobstructed. It is also recommended that the enclosure be ventilated at the top and
bottom to circulate the hot air.
Before fi nishing in the appliance test the operation using the remote control, cycling it through all
of its different
ADJUSTMENT" section.
inside of the appliance.
SEE-THROUGH
64"
162.6cm
MINIMUM
ENCLOSURE
HEIGHT
* Within the appliance enclosure a 3" (76mm) clearance between the top of the vent pipe and combustible
materials is required. All other clearances within the enclosure, including where the vent pipe exits the
enclosure are subject to 2" (51mm) to the sides and bottom and 3" (76mm) to the top for horizontal and 1"
(25mm) for vertical.
** See venting section.
W415-1539 / B / 11.22.16
INTO THE APPLIANCE OPENING.
modes, see "OPERATION" section. Check pressure readings, see "PILOT BURNER
Once fi nished in, access to the control components can only be done through the
NOTE: JOINT COMPOUNDS AND TAPES THAT ARE
RESILIENT TO HEAT AND CRACKING SHOULD BE
USED WHEN TAPING AND MUDDING SEAMS.
STEEL STUD FRAME
HEAT SHIELD
26 1/2"
67.3cm
MINIMUM
TOP OF
25 3/4"
APPLIANCE
65.4cm
OPENING
MINIMUM
NON-COMBUSTIBLE
COMBUSTIBLE
MATERIAL
WARNING
!
COMBUSTIBLE
3"
TOP OF
76mm *
ENCLOSURE
7" 179mm
TO SIDEWALL
NON-COMBUSTIBLE
0" IF NON-COMBUSTIBLE
FINISHING IS USED SUCH
AS BRICK AND STONE.
3"
76mm
2"
51mm
57"
144.8cm
MINIMUM
PLUS RISE**