Electrical Connection; Hard Wiring Connection - Napoleon LV38N Instructions D'installation Et D'opération

46

7.0 ELECTRICAL CONNECTION

EN EN
DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIED
SERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THE
RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THE
ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE
WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIAN
ELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 IN
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT,
If access to the control area is necessary BEFORE INSTALLATION, remove the pre-fi nishing access panel.
The access panel must be re-installed before operating the appliance.
Before fi nishing in the appliance test the operation using the remote control, cycling it through all of its
different modes, see "OPERATION" section. Once fi nished in, access to the control components can only be
done through the inside of the appliance.
7.1

HARD WIRING CONNECTION

It is necessary to hard wire this appliance.
Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired.
This appliance must be electrically connected and grounded in accordance with local codes. In the absence
of local codes, use the current CSA C22.1 Canadian electrical code in Canada or the ANSI/NFPA 70-1996
national electrical code in the United States.
W415-1539 / B / 11.22.16
APPLIANCE WALL SWITCH. INCORRECT WIRING WILL DAMAGE CONTROLS.
WITH THE GLASS DOOR OPENED OR REMOVED.
WARNING
!
ELECTRICAL CIRCUIT.
THE UNITED STATES.
69.2_2