9.1
GENERAL TRANSMITTER LAYOUT
Transmission
Flame ON
9.2
INITIALIZING THE TRANSMITTER FOR THE FIRST TIME
Power the receiver.
A.
Press the reset button to begin the programming process.
B.
The receiver will BEEP 3 times to indicate that it is ready to synchronize with a
C.
transmitter.
Install the 3 AAA batteries into the transmitter battery bay, located on the base
D.
of the transmitter, then press the "ON" button. The receiver will BEEP 4 times to
indicate the transmitter's command is accepted and sets to the particular code of
that transmitter. The system is now initialized.
NOTE: THE INITIALIZING PROCESS MUST BE COMPLETED WITHIN 10 SECONDS OF
PRESSING THE RESET/PROGRAMMING BUTTON.
RESET BUTTON
RECEIVER
Blower
Key Lock
Low battery alarm
Room
Temperature
CPI mode
Night Light
TRANSMITTER
W415-1349 / A / 03.18.15
39
EN