Front Surround Installation; Door Removal And Installation - Napoleon HDX40NT-1 Mode D'emploi

32
7.3

FRONT SURROUND INSTALLATION

Secure the front surround brackets using 6 screws. Ensure to drill the brackets into the wall studs, see Figure 1.
EN NOTE: The 39" (991mm) is measured between the bottom of the appliance and the center of the middle
hole of the mounting bracket.
Install the front surround. Lift the surround up and slide onto the brackets until secure, see Figure 2.
Secure the bottom of the surround with 2 screws, see Figure 3.
7.2

DOOR REMOVAL AND INSTALLATION

The glass door is secured to the top front edge of the
fi rebox with two latches. Pull the handles of the latches
forward, then lift the latches out from the door frame to
release the top of the door. Next, pivot the door forward until
the top edge clears the front of the appliance. Carefully grip
the sides of the door lifting it out from the retainer along the
bottom of the door. NOTE: These spring latches make
up the spring relief system for the appliance.
Ensure they open freely and close sealed.
Reverse these steps to reinstall the door and
safety screen. Ensure the safety screen is
installed correctly.
W415-1349 / A / 03.18.15
FIG. 2
FIG. 1
HANDLES
RETAINERS
" A "
3 9 " (9 9
1 m m )
FIG. 3