Lamp Replacement - Napoleon HDX40NT-1 Mode D'emploi

• Inspect all accessible gaskets and replace as required.
• Access the blower, if equipped and clean using a soft brush and vacuum.
• Re-assemble the various components in reverse order.
• Inspect the relief system. The appliance relieves through the main glass door or through the fl aps on the
fi rebox top. Ensure they open freely, and close sealed.
• Check the gas control valve pilot and Hi / Lo knobs move freely (if equipped) – replace if any stiffness in
movement is experienced.
• Check for gas leaks on all gas connections up and downstream from the gas valve including the pilot tube
connections.

11.2 LAMP REPLACEMENT

This appliance comes equipped with our "Night Light™". If in the event the lamp needs to be replaced, follow
these instructions.
Turn off all electrical supply.
A.
Remove the glass door, see "DOOR
B.
REMOVAL / INSTALLATION" section.
Unscrew the lens cover and lift the lamp
C.
straight out. Replace with Wolf Steel Ltd.
parts only (W387-0013).
D. NOTE: Do not handle the lamp with
bare fi ngers, protect with a clean dry
cloth.
Replace lens cover.
E.
Replace glass door.
F.
45
37.1C
W415-1349 / A / 03.18.15
EN