D
Fig. 11
Saw Band Line Setting
Fig. 12
Blade Door Locking
Cutting Height Set-Up
E
Fig. 13
Fig. 14
22
D Loosen butterfly nut (Fig. 2/ Pos. 19) under the
table and tilt the table - see F.
E The tilting angle may be read on the scale (Fig.
2/ Pos. 18). Retighten the butterfly nut (Fig.
2/Pos. 19).
F
•
Switch the machine off and unplug. .
•
The saw band line should be always set
prior to setting the saw band guide.
Check the saw band running by turning
the upper runner with hand. Adjust by
turning the line setting knob. (Fig. 2/Pos.
16). The band should run through the
runner centre as show in opposite figure.
Lock the set-up with butterfly nut (Fig.
2/Pos. 24) on the line setting knob.
•
Switch off the machine and unplug.
•
Having opened the door, loosen the lock
(Fig. 2/Pos. 2/5/10). Use a screwdriver to
do that. Remember to lock again when
closing the door.
•
Switch off the machine and unplug.
•
Loosen butterfly nut (Fig. 2/Pos. 4) and
locate the blade upper guide with
adjusting wheel (Fig. 2/Pos. 3) so that a
distance of ca 2-3 mm from the cut
material is retained. Retighten butterfly
nut (Fig. 2/Pos. 3).
GB