Troubleshooting - Festool PLANEX LHS 2 225 EQI Notice D'utilisation

13 Troubleshooting

The LED signals described in the table and errors relating to the Bluetooth
Festool Work app are only relevant for the LHS 2 225 EQI.
Problem
Power tool bumps/
does not run smoothly
over the surface.
Power tool does not
stop at ceiling.
Excessive material re­
moved from workpiece.
Surface quality is not
optimal.
Scratch marks on the
surface.
Extraction power of the
power tool is insuffi­
cient.
Possible causes
Suction power is set incor­
rectly.
Interface pad is damaged or
deformed.
Speed is set incorrectly.
Suction power is set incor­
rectly.
Grit on abrasive is too coarse. Select a finer grit, e.g. P240, P320.
Extraction power is insuffi­
cient.
Suction power of the power
tool is too strong.
Grit on abrasive is too coarse. Select a finer grit, e.g. P240, P320.
Speed of the power tool is too
high.
Spackling paste with a high
percentage of filler/soft filler.
Incorrect abrasive grit.
Drying times of the spackling
paste not observed.
Suction power of the power
tool is set incorrectly.
Spackling paste with a high
percentage of filler/soft filler.
Backing pad is placed down
on the surface at an angle.
Backing pad brake is worn.
Holes in the interface pad or
backing pad are clogged.
Incorrect abrasive.
Abrasive hole pattern does
not match the interface pad
hole pattern.
Remedy
Adjust the suction power until the cause has
been rectified, see Section
Replace the interface pad, see Section
Increase the speed.
Increase the suction power, see Section
See measures in the section entitled "Extraction
power ... is insufficient."
Reduce the suction power until the cause has
been rectified, see Section
Reduce the speed, see Section
Reduce the speed, see Section
Select a finer grit, e.g. P240, P320.
Read the technical data sheets and manufactur­
er's recommendations.
Adjust the suction power until the cause has
been rectified, see Section
Select a finer grit, e.g. P240, P320.
Place the backing pad parallel to the surface.
Have the backing pad brake replaced by an au­
thorised customer service workshop.
Vacuum the interface pad, backing pad and ex­
traction channels.
Always use original Festool abrasives with the
matching hole pattern.
Apply abrasive correctly, see Section
English
® connection or the
7.5 .
7.3 .
7.5 .
7.5 .
7.1 .
7.1 .
7.5 .
7.2 .
27