Oak Wood Log Placement (Olko36) - Napoleon Riverside Série Mode D'emploi

finishing
EN
9.2

oak wood log placement (OLKO36)

WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifically approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
PHAZER™ logs and glowing embers, exclusive to Napoleon, provide a unique and realistic glowing effect that
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing ef-
fect. Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat-activated curing process. Blocked burner ports can cause an incorrect flame
pattern.
Place log #1 on the rear bracket, ensuring the
1.
notch on the right side of the log fits around
the pilot shield. Do not cover any burner ports.
Place the hole in log #3 on the stud located on
3.
the left side of the burner.
22
W415-1796 / B / 08.01.18
note:
Log numbers are located on the bottom or back of the logs.
1
1
3
2
2
Place the two holes in log #2 on the two studs
2.
located in the center of the burner, ensuring
the light beige-coloured end of log #2 faces to
the right. Do not cover any burner ports.
3
2
4. Place log #4 along the front right side of the
grate and then pull it forward, ensuring the log
notches align with the grate posts.
Continued on next page
1
1
4