Minimum Mantel Clearances; Logo Placement - Napoleon Riverside Série Mode D'emploi

finishing
EN
WARNING
!
• Risk of fire! Maintain all specified air space clearances to combustibles. Failure to comply with these
instructions may cause a fire or cause the appliance to overheat. Ensure all clearances (i.e. back, side, top,
vent, mantel, front, etc.) are clearly maintaned.
• Never obstruct the front opening of the appliance.
• When using paint or lacquer to finish the mantel, the paint or lacquer must be heat resistant to prevent
discolouration.
9.3

minimum mantel clearances

We recommend all mantels be made from non-combustible material. However, if using combustible materials,
follow the chart below.
MANTEL
HEIGHT
note:
Mantel temperatures will rise above normal temperatures and may be hot to touch.
9.4

logo placement

Remove the backing of the logo supplied. Centre the
logo on the front of the appliance and ½" (12.7mm) in
from the left side, as shown.
24
W415-1796 / B / 08.01.18
20 1/2
18 1/2
16 1/2
14 1/2
8
2 4 6 8 10
MANTEL
DEPTH
MANTEL
2"
1"
35 3/4"
½"
(12.7mm)
½"
(12.7mm)
½"
(12.7mm)
½"
(12.7mm)
8"
6"
4"
TOP OF
APPLIANCE