System Interface Installation - elco AEROTOP SPLIT M-RX Guide D'installation

Installation guide

System interface installation

Positioning
The system interface recognizes the
temperature of the environment, so this
factor must be taken in consideration
when choosing its positioning.
We recommend to place the remote
control away from sources of heat (ra-
diators, direct exposure to sunlight,
fi replaces etc.) as well as from drafts or
openings to the outside which may af-
fect the operation of system interface,
should be avoided.
You are also required to place the inter-
face at least 1.5 m from the fl oor.
WARNING:
USE ONLY THE PROVIDED SYSTEM
INTERFACE.
WARNING
User interface installation has to be
done by a qualifi ed technician. Be-
fore installing the remote control,
disconnect power supply.
Wall installation
The Remocon Plus system interface
must be fi tted to the wall before the
BUS line is connected.
- connect the pair of wires to the
connector (fi g. 1);
- open up the holes required for
fi xing;
- fi x the base of the device to the box
on the wall using the screws sup-
plied in the kit (fi g. 2);
- position the system interface on the
base, pushing it gently downwards
(fi g. 3).
Connection to the installation
The sending, receiving, and decoding
operations are performed by a BUS si-
gnal protocol, which ensures the inte-
raction between the system and the
interface.
Connect the wires to the terminal block
included in the electrical panel of the
internal unit of the system.
NOTE: To avoid interference prob-
lems when connecting the system
interface and internal unit, use a
shielded cable or twisted pair cable.
BUS
B T
Fig. 1
Fig. 2
BUS
B T
B T
Fig. 3
SYSTEM
INTERFACE
INTERNAL UNIT
MOD. BUS
ANODE
TA 1 TA 2 SE TNK
GND A+ B-
+24V
BUS IN
BUF
B T AUX 1
79 / GB