System Interface; Outdoor Sensor - elco AEROTOP SPLIT M-RX Guide D'installation

System description

SYSTEM INTERFACE

134 mm
Technical Data
Power supply
Electrical absorption
Operating temperature
Storage temperature
Bus wire length and cross-sectional area
NOTE:
TO AVOID INTERFERENCE PROBLEMS, USE A
SHIELDED CABLE OR TWISTED PAIR CABLE.
Buff er memory
Conformity
LVD 2006/95/EC - EMC 2004/108/EC
Electromagnetic interference
Electromagnetic emissions
Conformity to standards
Temperature sensor
Resolution degree:
Product Fiche
Supplier's name
Supplier's model identifi er
Class of the temperature control
Contribution to seasonal space hea-
ting energy effi ciency in %
Adding an outdoor sensor:
Class of the temperature control
Contribution to seasonal space hea-
ting energy effi ciency in %
In a 3-zones system with 2 room sensors
Class of the temperature control
Contribution to seasonal space hea-
ting energy effi ciency in %

OUTDOOR SENSOR

16 mm
BUS
max. < 0,5W
-10 ÷ 60°C
-20 ÷ 70°C
max. 50 m
min. 0.5 mm2
Position the outdoor sensor on the north-facing wall of the
2 h
building, at least 2.5 m from the ground and away from di-
rect sunlight.
Remove the cover A and install the sensor using the wall
EN 60730-1
plug and screw B provided. Carry out the connection C
using a 2x0.5 mm
EN 60730-1
nection wiring shall be 50 m. Connect the wire to the ter-
EN 60730-1
minal by introducing it from the lower part after creating a
NTC 5 k 1%
suitable passage.
0,1°C
Place the sensor cover back in the correct position.
ELCO
Re- Outdoor
mocon sensor
Plus
V II
+3% +2%
VI --
+4% --
VIII --
+5% --
A B
2
wire. The maximum length of the con-
NTC R25 = 10K B (28/85) = 3977
Temperature [°C]
-30
-20
-10
0
10
20
25
30
40
50
60
Resistance [OHMS]
178.605
98.438
56.079
32.997
20.027
12.517
10000
8.042
5.302
3.579
2.469
63 / GB