Güde GRK 2134.1 BSL Traduction Du Mode D'emploi D'origine page 40

36
Do not use saw blades which are cracked, damaged,
or deformed.
Do not use saw blades made of high-speed steel.
Only use saw blades which are sharp. Replace blunt
blades with a new replacement.
Always use blades with correct size and shape of
arbour holes.
Saw blades that do not match the mounting hard-
ware of the saw will run off-centre, causing loss of
control.
Use only woodworking blades specified in this
manual, which comply with EN 847-1.
Do not use any flanges, washers, and nuts to secure
the saw blade other than those supplied or indicated
in the instruction manual.
It is necessary to select a saw blade which is suitable
for the material being cut. Never use the product
to cut materials other than those specified in the
intended use section in this manual.
It is important to avoid overheating the blade and
melting the plastic workpiece when cutting.
It is essential to adhere to the maximum speed spe-
cified on the saw blade. only use saw blade that are
marked with a speed equal or higher than the speed
marked on the tool.
Replace the table insert when worn or damaged.
Before work, make a dummy cut without the motor
turned on so the position of the blade, operation of
the guards with respect to other machine parts and
workpiece may be checked.
When performing mitre, bevel or compound mitre
cuts, adjust the sliding fence to ensure the correct
clearance from the blade.
The bracket stop must always be engaged when
transporting the product.
Keep the floor area free of loose material e.g. chips
and cut-offs.
Refrain from removing any cut-offs or other parts
of the workpiece from the cutting area whilst the
machine is running and the saw head is not in the
rest position.
Long workpieces must be adequately supported.
The working area of the saw includes the whole
extent of the workpiece. The operator should secure
this area from accidental contact from other persons
or objects which may move the workpiece during
operation.
The dust produced when using this tool may be
harmful to health. Do not inhale the dust. Use a
dust absorption system and wear a suitable dust
protection mask. Remove deposited dust thorough-
ly, e.g. with a vacuum cleaner. Do not replace the LED
or laser with a different type. Any repairs must only
be carried out by the manufacturer or authorised
service agent.
A power spike causes voltage fluctuations and may
affect other electrical products in the same power
line. Connect the product to a power supply with an
impedance equal to 0.233 Ω to minimize voltage
fluctuations. Contact your electric power supplier for
further clarification.
Safety Warnings Laser
The laser radiation used in this saw is Class 1 with
maximum <1mW and 650nm wavelengths. Do not
project the laser beam directly into the eyes of others.
Failure to comply with the rules could result in serious
personal injury.
Do not stare into beam during operation.
Do not project the laser beam directly into the eyes of
others. Serious eye injury could result.
Do not place the laser in a position that may cause
anyone to stare into the laser beam intentionally or
unintentionally.
Do not use optical tools to view the laser beam.
Do not operate the laser around children or allow
children to operate the laser.
Do not attempt to repair the laser device by yourself.
Do not attempt to change any parts of the laser device
by yourself.
Any repairs must only be carried out by the manufac-
turer or authorised service agent.
Do not replace the installed laser with a different
type.