Door Removal / Installation; Glass Media - Napoleon WHD48N Mode D'emploi

5.2

DOOR REMOVAL / INSTALLATION

IF EQUIPPED WITH DOOR LATCHES THAT ARE PART OF A SAFETY RELIEF SYSTEM, THEY MUST BE
PROPERLY ENGAGED. DO NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
A.
Remove the surround with safety screen.
(see "SURROUND INSTALLATION /
REMOVAL" section).
B. Remove the 5 screws that secure the
door.
C.
Lift the door up and off.
D. Reverse steps to reinstall the door and
safety screen with surround.
NOTE: A barrier designed to reduce the risk of
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
burns from the hot viewing glass is provided
with the appliance and must be installed.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
5.3

GLASS MEDIA

OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
CLEAN THE GLASS MEDIA PRIOR TO INSTALLATION. BEFORE APPLYING THE CLEANED GLASS, ENSURE THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
DO NOT CHANGE OR SUBSTITUTE THE GLASS MEDIA MATERIAL PROVIDED WITH THIS APPLIANCE. IF
REPLACING, USE ONLY THE REPLACEMENT GLASS MEDIA AVAILABLE FROM YOUR AUTHORIZED
GLASS MEDIA OVER THE BURNER MUST NOT BE MORE THAN ONE LAYER HIGH. MORE THAN ONE LAYER
OVER THE BURNER WILL CAUSE FLAME LIFTING AND SOOTING PROBLEMS.
DO NOT PLACE ANY MEDIA (GLASS OR VERMICULITE) IN OR AROUND THE PILOT OPENING. THIS WILL
Evenly spread the glass media onto the media tray, covering the burner tube and tray.
Glass media over the burner ports may cause a "Puffi ng" sound. To eliminate this sound, simply push the
media away from the burner ports.
NOTE: The distribution of glass media over the burner ports will infl uence the fl ame height. When the
fl ames impinge on the glass, the glass may discolour slightly and the edges may soften.
NOTE: Do not use more media than what was supplied with the appliance.
CLEANING GLASS MEDIA
Glass media may have a fi ne oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
THIS WARNING FOR ELECTRICS ONLY:
!
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
DEALER / DISTRIBUTOR.
INTERFERE WITH THE PILOT OPERATION.
WARNING
!
WARNING
WARNING
!
THAT IT IS DRY.
27
75.1A
75.1
74.1C
W415-1606 / 09.09.16
EN