Ceiling Fan Assembly - Emerson WELLAND CF610VS00 Manuel Du Propriétaire

BP7495 CF610 Welland.qxp_ BP7495 3/10/15 4:21 PM Page 5
3.1
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install
the ceiling fan mounting plate on the outlet box.
3.2
Remove the fan assembly from the protective
plastic bag. Place the fan assembly into the bottom
foam pad with the bottom of the fan assembly motor
facing up (Figure 1).
The bottom foam pad serves as a holder for the fan
during the first stages of assembly.
3.3
Remove the shipping spacers and the spacer
attachment screws from the motor before installation of
blade assemblies (Figure 2).
Discard the spacers and spacer screws.

3. Ceiling Fan Assembly

Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
5
WARNING
!
Figure 1
Figure 2
Please contact 1-800-654-3545 for further assistance
FAN ASSEMBLY
BOTTOM
FOAM PAD
SHIPPING SPACER
SCREW
SHIPPING SPACER
FAN ASSEMBLY
emersonfans.com
E.T.L. Model No.: CF610