Emerson WELLAND CF610VS00 Manuel Du Propriétaire page 10

BP7495 CF610 Welland.qxp_ BP7495 3/10/15 4:21 PM Page 10
3.14
While pulling up on the 4.5" downrod, retighten the two
setscrews (previously loosened) in the motor coupling
NOTE: The setscrews must be properly installed as
to secure the downrod into place (Figure 13).
described above, or fan wobble could result.
It is critical that the setscrews are securely tightened.
Failure to verify that the setscrews are properly
installed could result in the fan falling.
3.15
Make sure the grommet is properly installed in the
coupling cover then slide the coupling cover on the
downrod until it rests on the motor housing (Figure 14).
3.16
Place the ceiling cover over the downrod. Be sure both
the ceiling cover and the coupling cover are oriented
correctly (Figure 15).
3. Ceiling Fan Assembly
WARNING
!
(Continued)
4.5" DOWNROD
MOTOR COUPLING
RETIGHTEN
SETSCREW
Figure 13
4.5" DOWNROD
COUPLING COVER
GROMMET
COUPLING
COVER
Figure 14
4.5" DOWNROD
CEILING COVER
Figure 15
10
RETIGHTEN
SETSCREW
MOTOR
HOUSING
E.T.L. Model No.: CF610