Ceiling Fan Assembly - Emerson PENBROOKE SELECT ECO CF5200AP00 Mode D'emploi

3.1
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely down
the Downrod (Figure 1).
Remove the Pin from the Downrod, then remove the
Hanger Ball (Figure 1).
Retain the Pin and Hanger Ball for reinstallation in
Step 3.7.
NOTE: Do not loosen the Screw holding the Green
Ground Wire.
3.2
Separate, untwist and unkink the Two 80" Motor Leads.
Route the Two Motor Leads through the Downrod
(Figure 2).
3.3
Loosen the Two Phillips Head Set Screws in the Motor
Coupler for installation of the Downrod (Figure 3).
Seat the 4.5" Downrod in the Motor Coupler (Figure 3).
Rotate and align the Downrod Holes with all the Holes in
the Motor Coupler (Figure 3).

3. Ceiling Fan Assembly

5
PIN
HANGER BALL
PHILLIPS HEAD SET SCREW
(LOOSENED)
Figure 1
TWO 80" MOTOR LEADS (UNTWISTED)
Figure 2
LOOSEN
PHILLIPS HEAD
SET SCREWS (2)
Figure 3
GREEN GROUND WIRE
4.5" DOWNROD
4.5" DOWNROD
4.5"
DOWNROD
MOTOR
COUPLING