Ceiling Fan Assembly - Emerson LURAY ECO CF860B000 Mode D'emploi

3.1
Flip the upper foam pad over and place on a stable
working surface.
Remove the fan motor assembly from the protective
plastic bag.
Place fan motor assembly on top of the foam pad with
the upper motor cover supporting the weight of the
motor (Figure 1).
This will permit access for the blades to be installed.
3.2
Note: The blades will have screws installed from the
top and bottom into the motor assembly.
Carefully place the first blade onto the motor assembly
such that the large mounting flange with three holes aligns
with the three matching holes of the motor (Figure 2).
The two bottom blade mounting tabs should align with the
mating mounting ears on the other side of the motor.
Install three screws into the blade holes and loosely
fasten to the motor with a Phillips tip screwdriver.
Repeat this for each of the other two blades. Be careful
to align the edge of each blade with the edge(s) of the
adjoining blades to avoid scratching the paint.
Reposition the blades as needed to form a concentric
circle with uniform gaps between the blades.
After all three blades are installed and aligned,
completely tighten the nine screws. You may hear a
popping noise as the blade edges mate together.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade assemblies when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between rotating fan blades.

3. Ceiling Fan Assembly

Figure 1
BLADE LARGE
MOUNTING
FLANGE
BLADE
MOUNTING
TAB
Figure 2
5
FAN MOTOR
ASSEMBLY
UPPER MOTOR
COVER
WASHER HEAD SCREWS
(3 per blade)
BLADE (3)
MOTOR
ASSEMBLY