Staufenbiel EPSILON COMPETITION V3 Instructions De Montage page 26

EN
29
30
31
32
26
ARF VERSION ONLY
Glue a servo frame to the servo hole.
Bring the aileron servo to middle position with a
servo tester and mount the servo horn. Drill the
outer hole with a 1,6 mm drill.
Create a linkage like shown in the picture. The
inital length should be around 68 mm.
ARF VERSION ONLY
Connect the linkage to the servo and aileron
horn. Adjust the length if necessary. Screw the
latch to the servo frame to tighten the servo.