Safety Instructions - HSM 125.2 Notice D'utilisation

1 Proper use, warranty
The shredder is designed exclusively for de-
stroying paper. Depending on the cutting type, it
can also handle small quantities of the following
materials:
Shred width (mm)
Credit and charge cards
CDs
Disks
Its sturdy drive mechanism is not damaged by
paper clips and staples. Only on machines with
safety level HS Level 6 (1 x 5 mm) can the pa-
per not contain staples or paper clips.
The warranty period for the document shredder
is 2 years. In addition, there is a 10 year guar-
antee on the solid steel blade rollers (except for
security level 5, HS Level 6). This warranty and
guarantee exclude wear and damage caused
by improper handling or actions taken by third
parties.

2 Safety instructions

• Read the operating instructions before
switching on the document shredder. Save
these instructions for later use.
• Observe all safety instructions on to the ma-
chine.
Risk of injury!
Do not reach into the paper feed
slot.
Risk of injury from being pulled
in!
Keep long hair, loose articles of
clothing, ties, scarves, jewellery,
etc. away from feed opening.
Material with the tendency to form
loops, e.g. tapes, strapping mate-
rial, etc. must not be shredded.
0802
1.9 3.9 5.8 1.9x15 3.9x30
● ● ● ● ●
● ●
●
HSM 125.2
Keep paper shredder out of the
reach of children. Do not let the
shredder run if the person using it
is not present.
Switch the shredder off and dis-
connect it from the mains if it is
damaged, not working correctly or
before relocating or cleaning it.
Service work may only be carried
out by HSM Customer Service or
by the service technicians of our
contractual partners.
• Make sure that the mains plug is well acces-
sible.
• Before you insert the mains plug, make sure
that the voltage and frequency of your power
supply comply with the information on the
name plate.
• Make sure that no liquid gets into the shred-
der.
• The shredder may not be placed near a
heater or other heat source.
• The ventilation slots must not be blocked
or covered and there must be at least 5 cm
space between the shredder and any wall or
furniture.
• After putting the collection bag in place, push
the frame (with bar A pointing to the front of
the cupboard) back into the guide rails.
A
7