Attachments; Rear Discharge Guard Kit; Maintenance Battery Charger - GGP ITALY SPA TCX 102-122 Série Manuel D'utilisation

PROBLEM
12. T he cutting means do not
engage or do not stop promptly
when they are disengaged
13. U neven mowing and poor
grass collection
14. U nusual vibrations while
working
15. Uncertain or ineffective braking
16. E rratic forward movement,
poor drive when going uphill or
if the machine has a tendency
to rear up
17. With the engine running, the
machine does not move when
the drive pedal is pressed
18. T he machine starts to vibrate
abnormally
If problems persist after having performed the above operations, contact your dealer.
WARNING! Do not take on complicated repair work without the necessary equipment and
technical knowledge. The guarantee is automatically revoked and the manufacturer declines
all responsibility for any poorly effected repairs.

8. ATTACHMENTS

8.1 REAR DISCHARGE GUARD KIT

(Fig. 8.1 no. 41)
Used instead of the grass catcher when the cut-
tings are not collected.
8.2 TOWING KIT (Fig. 8.1 no. 42)
For towing a small trailer.
LIKELY CAUSE
– loose belt
– p roblems in the electromagnetic
clutch
– c utting means assembly is not
parallel to the ground
– i nefficient cutting means;
– f orward speed too high
compared to the height of grass
being cut
– c ollector channel is blocked
– c utting-means assembly is full
of grass
– t he cutting means are
unbalanced or loose
– l oose bolts and screws
– t he brake is not adjusted
correctly
– p roblems with the belt or the
engagement device
– release lever in position «B»
– d amaged or loose parts
8.3 CLOTH COVER (Fig. 8.1 no. 43)
Protects the machine from dust when not in use.

8.4 MAINTENANCE BATTERY CHARGER

This keeps the battery in good working order
when the machine is in storage, guaranteeing
an optimum level of charge and longer battery
life.
EN - 19
SOLUTION
– c ontact your dealer
– c ontact your dealer
– c heck the tyre pressure (see
5.3.2)
– r einstate the alignment of the
cutting-means assembly in
relation to the ground (see 6.3.1)
– c ontact your Dealer
– r educe the forward speed and/
or raise the cutting-means
assembly (see 5.4.5)
– w ait for the grass to dry
– r emove the grass catcher and
empty the collector channel (see
5.4.7)
– c lean the cutting means
assembly (see 5.4.10)
– c ontact your Dealer
– c heck and tighten all the engine
and frame bolts
– c ontact your Dealer
– c ontact your Dealer
– p ut into position «A» (see 4.33).
– s top the machine and disconnect
the spark plug cable
– i nspect for damage
– c heck for and tighten any loose
parts.
– h ave all checks, repair work and
replacements carried out by a
specialized Centre only.
(Fig. 8.1 no. 44)