Applying The Sling - arjo KKA5120 Mode D'emploi

Applying the Sling

Place the Sara Plus
Lean the patient forward and place the sling around
Position the bottom of the sling, aligned
EN
Make sure that:
• patient's arms are outside the sling,
• support belt is positioned loosely around the
patient's body and
• support belt is not twisted or trapped behind the
WARNING
To avoid injury to the patient, pay close
attention when lowering or adjusting the
spreader bar.
Position the Sara Plus lift in front of the patient with
Apply the brakes on the Sara Plus
Place the patient's feet on the Sara Plus foot
Lower the Sara Plus Arc-Rest as low as possible,
Sara Plus IFU
(See Fig. 7 )
(See Fig. 8 )
Sara Plus IFU
Sara Plus Flites: before the transfer of the
patient, make sure to use the relevant pair of
loop attachment in accordance with the patients
WARNING
To avoid the patient from falling, make sure
that the sling attachments are attached
securely before and during the lifting
process.
Once the cords are attached, pull and lock them in
the retaining cleats (A
Pull the cords so that any slack is taken up by each
cord and the back section supports the patient
Ask the patient to hold on to the hand grips with
their arms resting on the Sara Plus Arc-Rest. See
the Sara Plus IFU
the hand grips, adjust the patient's position by
See the Sara Plus IFU
Make sure the sling is attached correctly and the
the patient and make sure that the weight of the
patient is taken up by the receiving surface before
8
(See Fig. 9 )
(See Fig. 10 )
(See Fig. 11 )